Protocol Galileo Stealth Pinion Gear Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          20 minutes            

Sections

3

• Propeller
• 4 steps
• Housing
• 2 steps
• Pinion Gear
• 1 step

Flags

0

• BackProtocol Galileo Stealth

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Propeller               

• Remove the chrome shaft cover by lightly pulling it away from the drone.

Remove the chrome shaft cover by lightly pulling it away from the drone.

1024

Step 2

• Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.
• Be sure to apply adequate pressure when removing the screw to prevent stripping it out.

Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.

Be sure to apply adequate pressure when removing the screw to prevent stripping it out.

Step 3

• Remove the propeller stop from shaft by lightly pulling it away from the drone.

Remove the propeller stop from shaft by lightly pulling it away from the drone.

Step 4

• Remove the propeller from shaft by lightly pulling it away from the drone.

Remove the propeller from shaft by lightly pulling it away from the drone.

Step 5

              Housing               

• Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.
• Take care to place the screws in a safe place to prevent losing them.

Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

Take care to place the screws in a safe place to prevent losing them.

Step 6

• Separate the upper and lower housing units by lightly pulling the two housing units apart.

Separate the upper and lower housing units by lightly pulling the two housing units apart.

Step 7

              Pinion Gear               

• Lift the pinion gear off the motor shaft by lightly pulling it away from the drone.

Lift the pinion gear off the motor shaft by lightly pulling it away from the drone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Matthew Selting                     

Member since: 02/15/2018

432 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       UW Stout, Team S8-G4, Ogden Spring 2018                        

                                                  Member of UW Stout, Team S8-G4, Ogden Spring 2018 



                    UWSTOUT-OGDEN-S18S8G4                     


                                            4 Members                     


                                            6 Guides authored                     

steve Litchfield - Nov 12, 2019

Reply

where can i get pinion gears at

where can i purchase pinion gears